FabricationLife
 
 

Tig’d Up Tuesday review 2-25

Posted on

A little late on this weeks Tig’d Up Tuesday review, but always come to you with a recap of the previous weeks submissions. We had an abnormally high traffic rate on this Tuesday, which we like obviously! Make sure to check out our other Tig’d Up Tuesday reviews!

This weeks selection:

Justin Bloomer

“A twin turbo system for a c6 z06. Utilizing twin 7675 precision turbos and 46 mm gates. Fabrication done by Justin of No Corners Cut fabrication.”

1969152_736874179666221_1913586496_n

 

Richard R.

“Dimes and Weaves”

1891516_827035677313820_253850904_o

 

Len Mitchell

“Ripples or no? Which do u like?”

1970599_10201362321396242_491575067_n

 

Brad Harmer

“Up close and personal with a Powerhouse Racing 4″ titanium catback for mkiv supra! Fillet joint to a custom phr machined v band flange.”

1965435_612605555495128_997924957_o

 

Ben Gilbert

“A pair of 2″ 4 to 1 3.5 inch collectors fully purged, fabricated by Mike at Edwards Motorsport. Cheers”

1957438_10152184281241480_1201512237_n

 

Alex L./BP Autosports, LLC.

“Titanium wastegate dump tube. Low angle pie cuts and consistency are the names of the game. Filled with 0.045 rod and welded with a standard #12 lense setup.”

1621888_653252371379882_954902050_n

 

David Vanstone

“Suzuki gsxr throttle body manifold for a Peugeot 106”

1920330_612690548819962_3111864_n

 

Kevin Merryman

“12ga 304 .045 wire 100 amps”

1891147_612786178810399_823312222_n

 

Swing back in next week for our next installment! Also be on the lookout for our Intercooler Series!

Posted in BLOG | Tagged , , , , , , , ,

Tig’d Up Tuesday Review 1-21

Posted on 1

This was one of our most packed Tig’d Up Tuesdays in a while. We numbers of submissions, and work from all industries sent in. We chose 10 this week, and the page saw traffic from across the globe!

 

As we said before, we will be featuring more than 10 entries every week now, so make sure you get your submissions in. If we do not use them, please keep sending. We may use one you send on a future post in the page.

 

Here are the submissions:

 

The Turbo Elements 

“Some drops with some dimes”

1554516_594006017355082_895710187_n

Continue reading

Posted in BLOG | Tagged , , , , , , , , , , , , , , , , ,

Prep is Everything

Posted on 1

 

Recent conversation has prompted the topic of “Prep is everything” around here at Fabrication Life.  This is a rule, a token of wisdom that should help anyone produce higher quality welds and finished products.  Seriously, why should the end product of fabrication get all of the attention in the process?  We hope this will open our readers minds to the importance of quality prep-work in the grand scheme of fabrication.  It is one of the most important moments in the process and one that it often times overlooked – leaving the work much to be desired. Continue reading

Posted in FEATURED, HOW TO | Tagged , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,